Industrial Attachment at HIIS

DAY 2 – 6 JULY 2012

Morning Session

I have attend an interview with company Recron (M) Sdn.Bhd that located at Nilai,Negeri Sembilan. After interview session and discuss their offer, I have made a decision to not accept their offer because the department and job they offer not have any related with my course. So, I decided to stay continue my industrial training under Utem Holding.

Afternoon Session

After coming back to Melaka, I have come back to UTEM. We were ask by Encik Mazran to create a blog for each of us as a journal during this practical period. He instructed us to update our blog with the things that we learn every single day. Then, he have give us a task schedule and a time table for us to followed . The task table is arrange as below:

MORNING

9.00am -10.00am : Report Blog

10.00am - 12.30pm : Daily Chores

1.00pm - 2.00pm : Break Time

2.00pm - 5.00pm : Daily Chores

5.00pm : Dismiss

TASK	MEMBERS	DURATION
All	Parallel [All Member]	Week 1 – Week 4
- PCB/ Soldering
- Sensor à Vibration
è Sonar
- GSM Modem
PLC	Prequisite	Week 3
- GSM Modem	BENT	Week 5
IP Camera	BENT student
Offline
Wifi
Mechanical Prototype		Week 6 - Week 10
PIC
PLC

Our first task at this new practical places is PCB soldering. The first thing we need to do is to soldered an SMD component first because this surface mount components are very small, and therefore special precautions (in additional to those required when working with through-hole components) must be taken.

The equipment that we will use are:

Solder Iron

Solder Paste

TGK-493 anti-static absorber (ionizer)

Tweezers

solder leads

Gripped board

And the components that we need to solder is:

Power and reset button

2 x GA 12 diode

PW LED and LED_C4

Resistor 2.2KΩ , 2 x 330Ω , 2 x 10kΩ